Speaker Cable

Brand: kennerton
Product Code: SB-005B
Availability: Out Of Stock
Qty: + -
  • 1 cables included
  • Spade + Banana Connectors, O.D.:25.0mm
  • Gold-Plated Internal Shield
  • Corrosion-Resistant 24K Gold Contacts.
  • Heavy-Duty Internal Dual Strain Relief
  • High-Density Triple-Layer Shielding for Maximum Noise Reduction
  • Nitrogen(Nz) Gas-Injected Dielectric for Maximum Signal Strength
  • Nickel-plated metal housings
  • Wooden Gift-Box Package
  • RoHs Compliant
  • Length: 3.0 m


Obsidian speaker cable as an ultimate cable. Based on 4mm highest quality BC Copper inner conductors, which consists of 350 individual wires, twisted together, and arranged in matched custom pattern. This composition provides uncompromising low-end responce, while maintaining great high-frequency resolution

Two 4-mm2 oxygen free (OFC) inner conductors, lots of isolating layers of LPDE and PVC as well as a thick nylon mesh fabric, enable the highest signal quality and the ultimate protection from mechanical interruptions without losing the much needed flexibility.

The 26 mm thick Block PLK-900 has a very natural character and presents voices and instruments at their most natural.

Another noticeable feature is an Gas-Injected Dielectric.

Gas Injection is a new technology used for producing the physical foam dielectric of coaxial cables.

Before the introduction of such a technology the blowing up of the foam Low Density PE dielectric insulation had to be done by chemical powders, blended together with Low density solid polyethylene (LDPE) which, under the effect of extrusion temperature decomposed the powders into gas.

This method limited the mechanical strength of the dielectric and jeopardised the life of the relative attenuation values. This applies particularly to cables installed in very damp environments.

An insulation made of nitrogen gas physically injected into High Density Polyethylene (HDPE) produces a foam dielectric granting the better mechanical, electrical and ageing performances than the chemical dielectric and almost equivalent to the solid polyethylene dielectric.

This is particularly beneficial where a coaxial cable is exposed to crushing, squashing and several bending manoeuvres during installation. The gas injected dielectric also ensures a better life span and stable attenuation values. In accordance with IEC 68-2-3 requirements which prescribes an ageing test of 21 days at 40АC and relative humidity of 93%, checks have shown that attenuation increases less than 5% over original values.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: